1999 Ford Explorer "position body mount" Questions

Ad

...position the IAC valve on the throttle body. Install and tighten the retaining screws to 71-106 inch lbs. (8-12 Nm). Attach the wiring harness connector to the IAC valve. Connect the negative battery ...

Ad

...position sensor, throttle body motor, and the ignition coil. when the throttle body motor was changed there's no electricity running through. Does anyone know the answer to this problem? This ...

Ad

Body Where The Air Intake Come Into The Engine It Is mounted With Two Screws And Has Three Wires TPS Stands For (Thottle Position Sensor) If The Sensor Goes Bad it Can Cause The Trans To Go Into Whats

Question about Ford Explorer

1 Answer

...Position the solenoid on its mounting bracket and install the retaining nuts. Attach the main emission vacuum control connector and the wiring harness connector to the EVR solenoid. Connect the ...

...body to the IACV look blocked again clean them out thoroughly. 2) Throttle position sensor - How to check? The socket for electrical connection with the TPS has 3 pins, one for 'ground', one for 5 ...

Question about Ford Explorer

1 Answer

...position without snapping back to prevent damage to internal components. 2. Place a drain pan under the vehicle to catch power steering fluid after you remove the two hoses from the steering pump. 3. ...

...body right after you turn the switch on. If you hear it come on then the problem is probable some where else. THIS MODEL FORD EXPLOER CAN COME WITH 3 CHOICES FOR A FUEL PUMP , U HAV THE MECHANICAL ...

Question about Ford Explorer

1 Answer

position it out of the way. The fluid lines do not have to be disconnected. Detach the accelerator and transmission control cables from the throttle body, and the control cables' mounting bracket from

...body work. The diagram seems to show that the hinge goes into the firewall, so if you want you might have to cut into the firewall, but this is more of a salvage yard procedure. I would look at the ...

Question about Ford Explorer

3 Answers

body brace. Remove the lower radiator hose. Disconnect the heater hose at the pump. Rotate the belt adjuster out of the way. Remove the water pump attaching bolts. Note their location for installation

Not finding what you are looking for?
1999 Ford Explorer Logo

3,360 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

1998 Ford Explorer
1998 Ford Explorer

2,998 Questions

1996 Ford Explorer
1996 Ford Explorer

2,307 Questions

2002 Ford Explorer
2002 Ford Explorer

2,302 Questions

2004 Ford Explorer
2004 Ford Explorer

1,513 Questions

2003 Ford Explorer
2003 Ford Explorer

1,369 Questions

Top Ford Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

xxxxxx xxx

Level 3 Expert

5117 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...