1999 Ford Explorer "new thread" Questions

...EXTENSION..YOU CAN BUY SOCKET AT ANY AUTO PART STORES.REMOVE OIL PRESSURE SWITCH. WHEN INSTALLING NEW ONE MAKE SURE THREADS HAS SOME KIND OF SEALER LIKE TEFLON TAPE CAN BE USED ON NEW OIL PRESSURE ...

...and it is not suggested by ford to "shorten" the lines by bypassing the radiator. sometimes a new "o" ring and cleaning inside the fitting where the spring is will help. however, unless you can ...

compass & outside temp gauge does not light I've checked dimmer etc. overhead console Car Forums and Automotive Chat old forum but good info to start with & you could always start a new thread.

...faster and easier than using the drain! There is a seal and o-ring on the petcock. You will need a new o-ring or buy a petcock that has new seals on

...don't hear anything try hitting it while the key is still on run. Sometimes this helps. Still get a new pump even if that helps. Trust me! If the fuel pump works, check to see if there is fuel ...

2002 explorer, will not start, turn key just clicks, have new batt and stater but still clicks when key is turned. what could be the problem There is a starter solenoid on the passenger side fender ...

...new plug and do it very carefully as there may be carbon in the treads the plug screws into. Screw it in until you feel it getting tight and then turn it back. Keep turning in and out until it fully ...

...new thread with the results of your checks, and we'll go from there. **If the front driveshaft does not turn, the transfer case is locking properly and we need to continue searching. Step 4) With the ...

...be the sending unit fuel line rusted and "cracked" after braking the bolts you might have to tap new threads to get the skid plate off then replace the sending unit. Hope this helps seen alot of

they haven`t been damaged.if so then you will have to run tap into the threads to clean them so the new sensor will go in properly