1999 Ford Explorer "master cylinder" Questions

master cylinder. it can go bad without leaking. the fluid bypasses the internal cups causing a fall in the pedal. also if you broke the lines lose to do calipers you might have air in the system bleed

...master cylinder to seize...try to bleed the master cylinder, if no line pressure is found in either of the two lines replace the master cylinder and re-bleed the entire system....good luck, marty I ...

...master cylinder. You can try bleeding the master cylinder itself, just to see if you have pressure there. But if you cannot pump them up, I'm betting on a bad master cylinder. I hope this helps

...master cylinder My vote would be the Master Cylinder. I had a truck sit for 4 years. After getting running again, it did the same thing you're describing. No brakes. I ended up replacing the Master ...

...MASTER-CYLINDER" or the "VACUUM-BOOST" unit and get it checked NOW B4 YOU CRASH!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! If there is no brake fluid leaking at any of the wheels then your looking at a ...

...master cylinder after you slide off the plastic clip. thanks You are definitely loosing hydraulic fluid in the system. If it is not the master cylinder it may be the slave cylinder down below. You ...

...master cylinder where the compensating port is blocked and that keeps the pressure plate partially disengaged so check that the clutch is properly by bleeding the nipple at the slave cylinder and ...

...Master cylinder, low on fluid. Refilled fluid, bled brakes...same thing happened again. Spongy brakes, low fluid, definitely air in the lines, but no fluid leaks apparent anywhere. Where the heck is ...

master cylinder was ? You did push the pistons in didn't you ? Over flowed from master cylinder ? After replacing pads you didn't pump up the brakes ? The pedal will go to the floor but should pump up

Master Cylinder replacement I replaced the brake master cylinder in my 1996 Explorer now I have no pedal at all I bled the master cylinder before I installed it. Do I just need to bleed the brakes now