...heavy duty washers you can use a standard 3 hole puller to remove the balancer. The threaded holes for the 6mm bolts are about 2" inside the access openings that are located on the face of the ...
washer. Connect the parking brake cable to the parking brake lever. Install the anchor pin plate, and place the cable anchor over the anchor pin with the crimped side toward the backing plate. Install
...washer will help your ground wire maintain solid contact with the car body. Use a ring terminal on the end of the ground wire, to keep it securely fastened to the bolt or screw. If you cannot find a ...
...works, made many) some guys just use impact gun and strip the treads out of the crank and the new FSMs all say, (DONT DO THAT, exactly) in a shop the dork that does that , just calls you and say, hey ...
...Heavy Duty Washers that can fit on the the Lug Studs. Place the Lug Stud back into the Wheel Assembly from the Rear (Rotors) or from inside (Drums). Use High Temp Grease for the area of the Lug Stud ...
...Washer. #4) Now you'll pull your Hub Assembly Off ,The Outside Bearing will more or Less Fall off the Hub.But you'll need to Remove the Outer Bearing Race Its the Metal Angled Race. #5) Before you ...
...Go and buy he heavy duty washer fluid with the lowest freezing point you can buy and refill your washer reservoir with it. Don't add any water Most likely you had water in the reservoir and it
1,980 questions posted
Usually answered in minutes!
2,348 Questions
2,262 Questions
2,120 Questions
1,869 Questions
1,365 Questions