1998 Ford Taurus "knock sensor located" Questions

...knock sensor located on a 2000 ford taurus with a 3.0 liter 6 cyl pushrod engine? I could not find a knock sensor on the 3.0L 6 cyl engine in my online resource. There were lots of other sensors, ...

Knock sensor location 04 Taurus duratec engine I have an '02 model of the same and they are located on either "side" of the block. There are two, one for each side but am not sure if there are others ...

the lower water hose was replaced ,,then check make sure the crank sensor was not knock off..Or the wire connector..It will be located around the harmonic balancer..Thats the lowest pulley on the car.

...Knock Sensor Improperly connected or faulty knock sensor. 18Inspect Ignition Timing Incorrectly adjusted engine timing. 19Inspect Piston Ring Set Worn or broken piston rings. 20Inspect Fuel System ...

sensor could be stuck at a low temperature,,which would cause the vehicle to make a cold start..Which would cause it to run rich...You really need to see it on a data screen,,to see whats its reading.

...knock), and/or a hesitation/surge on acceleration. Causes: A code P0171 may mean that one or more of the following has happened: * The MAF (Mass Air Flow) Sensor is dirty or faulty. Note: The use of ...

...knock sensor located? Thanks Under hood, passenger side, lower engine area, above engine mount, mounted in engine block .This what it looks like hope this helps Upper Middle Rear side of engine under ...

...knock sensor ford taurus lx 1998 3.0 l SOHC screw into the side of the engine block, will only have on wire going to it, good luck. The sensor is most easily accessed from underneath the vehicle. The ...

...knock, and backfire some. It acts like the fuel is too lean or too rich, then it will line itself out. It used to only take about 15 min or so to cool and start, but now it is getting progressivly ...

...knock sensor replacement Hello, Try these 2 sites where I located your part. Car-stuff.com shows some of the part numbers that will fit, if you read your original numbers off the part. The ...