1998 Ford Explorer "change ignition coil" Questions

ignition has no spark. Ihave changed the coil and crankshaft sensor check for power at the coil wiring harness At the base of the distributer is small ignition module board. Remove it and take it into

...change them IF YOU HAVE THE EI IGNITION SYSTEM.YOUR SPARK PLUGS IS UNDER EACH INDIVIDUAL COIL.DISCONNECT COIL ELECTRICAL CONNECTOR.THEN REMOVE COIL RETAINING BOLT.THEN REMOVE OFF SPARK PLUG.THEN ...

...high-voltage pulses from the ignition coil to the spark plugs. The spark plugs: change high-voltage pulses to spark at the gap, which ignites the fuel and air mixture. The firing order is

...change it is missing so bad it will not rev above 2800 rpm any help If this is a coil pack ignition system (no spark plug wires, just a coil pack on each plug), this sounds like you may have a coil ...

...change out first? coils, plugs, wires? thanks Does your engine turn over?When you say your upper hose blew off To me it meant your engine ran hot.You put the hose back on and filled the truck with ...

...ignition control system for a 1992 Ford Explorer 4 wheel drive V-6 Vehicle abruptly stopped running and has no spark, changed ECM, crank positioning sensor, changed the coil, checked all fuses, ...

...coil so i changed it, no luck. it feels like a plugged converter so i disconnected at the manifolds, still no luck. any thoughts Spark Plugs COP Ignition Coils Failed Converter O2 Sensors Clean ...

I have a 1997 ford explorer 4.0L EFI put new plugs and wires and ignition coil in and i still have a misfire change distibuter also

...ignition coil defective. The sparks plugs and wire were just changed. After driving it a couple days the light hasnt cut off and there is still a midst upon take off. I purchased a coil-ignition but ...

...sea foam in gas to take out impurities If this is the only misfire code you get, I would have a close look at my ignition coil. It might also be a good idea to check the compression on this