1997 Ford F350 Crew Cab "tank guages" Questions

...guage went to 1/4 and sat there. Any tips? Fuel guage wont work. I'm assuming this has dual tanks, do you know if it is not working on both tanks ?  Most people would check the circuit ...

...guages on either tank are not working.When I disconnected the wires on the front tank the guage went to full and when I reconnected it went right back to empty.I checked the fuses and they seem to be ...

fuel guage inoperative Fuel gauge on full is usually a bad sender (in the tank). 0-400 ohms should give a reading (200 ohms is half a tank - not sure if this is the exact number). Bad connection could

...guages showed full but were empty. If the valve is damaged it coould have been using the front tank with the rear also, although it is not supposed to happen it did on this particular truck.You may ...

fuel guage 1990 ford superduty dump truck not working Have you checked for power and ground at the sending unit in the tank ??

...are tight. What is going on? Also the fuel guage (sometimes) shows full when it's got only 1/4 tank of fuel, but eventually goes back to normal in a few miles. Is there a possibility of water ...

the pump, it can cope with some air when running without any misfire, the fuel will run back to the tank after time and need re priming. Has anything been changed in the fuel system lately? THOSE TYPE

...WHEN GAS IS IN IT To confirm if the fault is with the Rheostat float within the fuel tank or the fuel guage in the dashbboard, you can remove the wiring to the fuel tank float. If ...

...wire and the guage jumps to full then faulty guage if nothing maybe bad ground on the tank itself. the guages are a reostat like a tyco race car gun the more it moves the more it grounds .. good ...

...you start the car the needle in the gas guage goes from the bottom right all the way past the full tank marker and goes all the way to the bottom left. Ive checked the fuses and they seem to be ok. ...