...cylinder head off and replace the head gasket-it is probably the reason for coolant in the cylinder. A good idea to have the head checked for cracks and for straightness of the head surface with the ...
...cylinder head I have 1988 F150 4.9L6 need torque specs for cylinder head and rocker arms for cylinder head the torque is : step 1 55 ft-lb, step 2 65 ft-lb, step 3 85 ft-lb. Rocker arm stud nut or ...
...cylinder head bolt,main bearing and connecting rod bearing for a 1997 Ford F 150 4.2 liter? Thank you... Cylinder heat bolt torque: Torque sequence --------- front | 7 3 1 5 | | 8 4 2 6 | --------- ...
...cylinder head bolts in the sequence shown in three steps, as follows: Step 1-27-31 ft. lbs. (37-43 Nm). Step 2-tighten an additional 85-95 degrees. Step 3-tighten another 85-95 degrees. Fig. Fig. 9 ...
...cylinder head. These are usually caused from the engine over heating. if the leak is that server a quick check would be to fill the radiator with water and leave the cap off, then crank the engine ...
Cylinder Head Temperature (CHT) Sensor -4.6L and 5.4L Removal Remove the intake manifold; refer to Section 303-01B . Remove the cylinder head temperature (CHT) sensor. Disconnect the connector. Remove
Question about Ford F-150
I have a 2014 Ford F-150 with a 5.0 and I am looking for the location of the cylinder head temperature sensor. In the cylinder head.
Question about Ford F-150
...cylinder head temperature sensor located on 2014 f150 5.0 https://www.f150forum.com/f38/cylinder-head-temperature-sensor-403678/ ...
...cylinder head and one on back of block between trans and engine. 8 cylinder both sides of engine block, both ends of cylinder heads and back of block between trans and block. I am not sure where all ...
1,829 questions posted
Usually answered in minutes!
2,636 Questions
1,214 Questions
1,298 Questions
1,038 Questions
974 Questions