...starter to the side. Next you'll need to remove the rear tranny mounting bolt. Then remove the crossmember from the frame. This is where you'll wish you hadn't started this job. You must support the ...
...replace the flywheel with the one that come with your new engine because the gears on both flywheel are different and the speed sensor will have difficulty reading the gears.Therefore the car will ...
...starter and still had problem. The flywheel had missing teeth. U replaced the mass air sensor while I was at it. Now it turns but sounded rough. Still not starting.At least it was starting before all ...
...replace worn out (automatic-style) flywheel which no longer engages starter. Shade tree mechanic says he hooked back up the one wire harness to transmission when he finished; but this sounds like an ...
...starter failing but that would not explain the shut off..could be a sensor within the engine i would have the alternator tested too.. I have a 2001 E320 which just stopped running at a very low speed ...
...starter mounting port in order to gain access to the converter bolts. For the Diesel Engine and 7.4L/5.7L Engines: Remove the four bolts securing the converter cover to the transmission.Mark the ...
...starter. Mark the relationship of the flywheel to the torque converter for reassembly. Use the J 43653, Flywheel Holding Tool, to prevent the crankshaft from rotating. Remove the torque converter to ...
...replace automatic transmissiion cable the shifter cable (not TV kick down) you detact it from the shifter (removed) the detach it from the tranny. it has 2 ends, detach them. of never done a cable ...
...flywheel housing above the starter motor mounting. A common symptom is Hesitant acceleration, acceleration ceiling - Miss-timed ignition due to a faulty CKP signal can be exacerbated by increased ...
619 questions posted
Usually answered in minutes!
706 Questions
694 Questions
653 Questions
589 Questions
617 Questions