1996 Ford Bronco "interior door lock locks half" Questions

...interior door lock stem up and down until the finger on the actuator lines up with a hole on the plastic part of the interior lock stem. 16. I Want to thank TommyRox in Texas on Ford Truck World and ...

interior door panel off? I would confer with your Jag dealer on this one. Removing the door panel with the door closed is a real problem and they may have an easy fix without risking damaging anything

door is stuck or jammed in the closed position. The push bottom on the interior handle is half way down (not popped up as usual) when it is closed. The lock is also half way locked on the sliding door

interior of door and pry/pop the hidden plastic rivets, releasing the soft interior away from the metal or the door. 3, You may have to twist off the latch, just like a bottle cap. 4, You will see the

...locks after about a minute with the doors closed , heater blower is stuck at one speed(about half speed) and one of the front interior lights fails to work, a friend said it might be a faulty relay ...

Interior lights flicker all the time. The auto door lock is only half the time. The only way to get the lights to stop is to bump the turn signal arm. Sounds like a Body Control Module or a PCM issue.

...the door is open. Does the interior light come on when you open the door? The microswitch in the ignition lock that identifies there is a key in the lock. Or it needs reprogramming by the

door, the interior light comes on, albeit with a slight delay, the alarm does not sound. If the light doesn't come on, it sounds after about five seconds. Any advice please? Thank you Andrew F

...door locks? Yes but if the interior lights are working then its getting power, i would check the switch itself, and also check the wires coming into the door there located where the door hinges are, ...

...interior door panel: Unscrew and remove the push/pull thing used to lock and unlock the door manually. Remove the 2 Phillips screws on the sides of the interior door panel. Remove the Phillips screw ...