1994 Ford Thunderbird "heater blend door" Questions

...heater core, this is called (interestedly enough) the air temperature control blend door actuator. The motor that moves this door fails because the door starts sticking from warping, most ...

...blend door actuator. Slide heater core (18476) and seals from the A/C evaporator housing. Installation Install the heater core in the A/C evaporator housing with the tube gasket on the outside of the ...

...heater temperature control blend door actuator checked, that is the usual problem, the actuator moves the air temperature control door that moves back and forth to supply hot and cold air or a blend ...

...I do not hear a vapor door open when I turn the heater on like when turn on the a/c. it is your blend door actuator behind the dash - hard to do but possible, my opinion would be to take it to the ...

...blend door vacuum line for hot and cold problem. You have a hole in your heater core. If you do not care about clogging your radiator (slightly) add aluma seal. The small plastic tube that looks like ...

Where is a/c heater blend door actuator located? 1995 Ford Thunderbird Workshop Repair Service Manual PDF Download for the easy solution download the pdf file

...blend door" or a "blower door" like other dual temp climate control systems. It's buried under a bunch of other stuff in the passenger side front of the engine and has about 3 heater hoses connected ...

...heater blend door not to close properly, and allows heat from the heater core to mix with the refrigerated air. Check refrigerant pressures to verify that sufficient charge is present, and make sure ...

...Heater will not work. Changed the Blower and the Heater Contol Box Might be a clogged heater core. Could also be a blend door motor Make sure you have antifreeze up to proper level. ...

heater core is stopped up or you have a problem with the blend door under the dash. If the temp gauge is staying around the cold mark the thermostat is not closing to warm up the engine. I am assuming