1994 Ford Taurus "spark plugs" Questions

spark plugs in my 2004 ford Taurus It seems I have to remove the intak assembly to access the rear plugs. what do I do to remove the intake safely and properly replace everything? Hello, You will have

...spark plugs were broke. He did a complete tune up and it ran great for about 2 weeks and did it again. Another spark plug (new one) broke. What could be causing spark plugs to break? USING WRONG TYPE ...

...spark plugs spark plug make sparks inside combustion chamber, make the engine run. if your ford taurus is a V6 than you have 6 of them. each piston required on plug. with out the spark plugs the ...

spark to the plugs ?It started once using starting fluid and ran nice for about one minute until I shut it off.What other componants should I look for to my 1993 ford taurus GL 3.8lt? thank you much !

...spark plugs are 1 2 3 ,so its the one in the back, far left (drivers side) You dont say why you want to know. If you have a misfire on number 3, you shoul dreplace the spark plugs with the correct ...

...spark plugs, spark plug wires, coil/coil pack(s), etc.) In my experience, the lesser amount of electronics you have, the easier solving the problem will be. This answer applies only to gas powered ...

...plugs wires for damage or just replace if you have replaced the #3 plug already if not replace it also first, check the spark plug and wire going to the number 3 cylinder on the engine( # 3 cyl. is ...

...plugs & wires. now it reads that the fuel leveling sensor is bad, will this help? If there is a misfire, the cylinder that it is misfiring in will be recorded as a code in the computer. Have the ...

...ago and ran great. Now it just wont start. It has a new battery. It doesn't seem to be getting a spark. Your distruber cap may need to be replace or re-aligned if your not getting spark. I would ...

...spark plugs and plug wires what`s the easiest way ( Ican already see is`t not easy) to change my spark plugs and plug wires on my `98 Ford Taurus 3lt DOC. This should not be too difficult with simple ...