...remove bolts and crossmember. NOTE: Do not remove the transmission support member NOTE: You may also need to remove the exhaust pipe from the engine manifold and also at the converter on some Probes. ...
...I can how do line it back up for installation remove the starter and get the bolts through there. let me know unbolt starter. remove access plate .should two bolts. then you can access converter ...
...bolts are off.... Then try to remove the transmission... You absolutely have to unbolt the torque converter or it won't pull out. The space to get those bolts out will be fairly tight.. A ratchet ...
...torque converter will bolt up in any position. Pre 96 converters were not 90 dgrees and you have to line up a 0 on the converter to a small hole in the flex plate. if the converter will not line up ...
...converter with the transmission as a unit ) use an impact gun , remove the crankshaft bolts for the flex plate making you keep the washers in the correct order for the new plate fit the new ...
...torque converter came out of the transmission front fluid pump. If it did, and you bolted it back together with out it being "locked" into the front pump, the front pump gears more than likely were ...
...remove the inspection cover by the starter and unbolt the torque converter. Don,t lose these bolts, they are special order only from the dealer. Unhook your linkage and wiring. Put a jack under the ...
...bolts. when u remove the suport mounts u should be able to see the top bolts. also u need to use a flat screw driver to turn the fly wheel. and unblot all 3 of the torque convert bolts . should be ...
...bolts. Position gear clear of frame. Remove front engine mount to frame retaining nuts, then front and rear transaxle mount nuts. Disconnect lower ball joints from steering knuckles, then remove ...
94 questions posted
Usually answered in minutes!
235 Questions
215 Questions
166 Questions
158 Questions
87 Questions