press...or, take it to NAPA or similar store that presses joints....but you have to remove the lower control arm and take it in. That can be the cheapest route also.....saves A LOT from labor from the
...press the new one in,, if its rivited then dril the rivets out and blamo RAISE AND SUPPORT VECHICLE SAFELY.PROPERLY SUPPORT THE LOWER CONTROL ARM.THE CONTROL ARM MUST BE SUPPORTED SO THE SPRING AND ...
...press the lower balljoint out of and into the A frame arm. So you either need to remove the whole A arm, or use a mobile press that can do it on the spot. ...
...and remove the strut and then purchase or rent a Ball joint press or remove the lower control arm and have a machine shop press the joint out. U will need a front end alignment after this is
...lower ball joint . it was being held on by pins but the new ball joint i purchased has bolts you must grind off the rivets,(or use an air chisel) and then use the supplied bolts. very common. ball ...
Question about Ford Tempo
front balljoints, do they press out down or up out of the lower control arm replacement of front ball joints theres different kinds allkinds some bolt on they press out easy in a low ton shop press..
how to replace ball joints Upper --Screws in Lower --4x4 Pressed in Lower 4x2 --Screws in
lower ball joints and idler arm. Bring it to your mechanic this is not easy you need to take the wheel off unbolt the axle if you can get the axle out without taking off the ball joints than do so but
...lower ball joints on a 1999 ford ranger ??? Ford Ranger Ball Joints 1993 through 1997Ford Rangers from '93 to '97 2WD have an "I-beam" front suspension as opposed to the upper and lower control arms ...
Question about Ford Tempo
lower control arm. Then removed the 2 bolts on the strut so I then had the entire steering knuckle to take to the machine shop. I did attempt to hammer out the bearing myself. The bearing innards came
156 questions posted
Usually answered in minutes!
316 Questions
207 Questions
136 Questions
161 Questions
112 Questions