1990 Ford Probe "scaner drive" Questions

...drive light indicator blinks and the car does not move? Have you checked the transmission fluid? if the D ligtlinks is a transmition problem the most comon problem is the lack of transmition oil but ...

...scaner reads no curant coads .reset all codes in memory, drive less than a mile all lights back on. also these lights go on and off rondomly on gose on another goes off . tried 4 differant scaners ...

drive does ok in reverse Car died check code with scaner code was p1391 changed cam sensor now car is ok in reverse but when you put it in drive it dies acts like it is stuck in hi gear were the codes

...driving for a while THERE IS AN ELEC. PROBLEM WITH THE TRANS. NEED TO PULL DATA AND CODES WITH SCANER TO PIN POINT THE PROBLEM. THE BLINKING LIGHT IS LIKE THE SERVICE SOON LIGHT ON, COMPUTER

...the car on the freeway at 65 mph the car start shaking bad and I check for a misfire I put mi scaner to see what culd a find but I dint get no codes its more likely to be bad wheel

...drive lights stay on(snow,gravel,tar) engine light stays on USUALLY A FLASHING ENGINE LIGHT MEANS A MISS FIRE CODE DID YOU HAVE THE VEHICLE HOOKED UP TO A SCANER? IM NOT UNDERSTANDING WHAT YOU MEAN ...

...was driving on the highway yesterday and the car just shut off, the lights, blinker and police scaner worker but when not turn over. I put the hazard lights on thinking I ran out of gas. I went ...

...so in 5th i was going 50kmph. Try to perform throttle adaptation. You will need VAG COM or similar scaner. Better yet , take it to mechanic

...SCANER IT SHOWS PO365 WICH STAND FOR CAM SHAFT POSITION SENSOR B DO I NEED TO RESET THE SENSOR OR THE ECM/PCM PLEASE EXPLAIN ME WELL WHAT TO DO AFTER REPLACING THI PART AND THE SETING THANK YOU. How ...

...s an electronic or mechanical part. Agreed with yogegoy, Old days are gone , on diagnostics without scaner you have small chances to find the problem . But you can check basics - Spark(you said it's ...