1990 Ford Mustang "mass airflow" Questions

...mass airflow sensor plugged in when the mass airflow sensor is plugged in the engine shuts down. looks like the timing is jumping around a little bit but its probably because the engine isnt running ...

...DIES OUT, IF I REMOVE THE 3" INTAKE DUCT BETWEEN THE MASS AIR AND THE THROTTLE BODY IT THROTTLES UP JUST FINE. (NEW MASS AIR) Yep you need a replacement mass airflow sensor. I had the same ...

...very slow throttle response Have you checked fuel pressure? Also changed fuel filter? Could be throttle position sensor or mass airflow sensor if you have one on this car. checked plugs, wires

what happens when u unplug mass airflow sensor in 2000 ford mustang gt 4.6 Car will lose power and not run proper and service light will stay on.

what would cause a 2002 ford windstar to stall when first started but run well when its warmed up I already replaced the cam sensor tps or mass airflow could cause what codes you getting

vaccum leak, mass airflow sensor, dirty injectors,and so on im in desperate need of a diagram for all vaccum lines, as well as anynway to manually adjust the idle thanks for ur time Here's a link

...I would check, This code means that there is a fault in your IAC valve located near the throttlebody. P1504 code on OBDII, sounds like you need to check and or replace your Mass Airflow Sensor

...t run with the maf sensor plugged in. you need to replace the mass airflow sensor it is defective for that year should be cheap but most likely will need to be ordered please leave 4 thumbs if it ...

...up. the car has MSD coil pack, brisk spark plugs gapped at .030. it could be something with mass airflow sensor make sure whomever installed the supercharger replaced or reflashed that ...

...Mass Airflow sensor , Verify that the Mass Air Flow Sensor wiring is connected properly and that there are no broken / frayed wires. Unplug and reconnect the MAF wiring harness Check the voltage of ...