Question about Mitsubishi Cars & Trucks
...car. Repeat these steps for each of the 2-row seats you want to remove. It's important to follow proper safety procedures when removing seats from a vehicle. Make sure to wear gloves and eye ...
Question about Cars & Trucks
safety switch, there could be 3 to 4. the seat, deck/clutch and brake/park,reverse. Look in your manual for there location. You may have to get a small engine tech. to check it out. Check the attached
...seat and the trunk space. This will give you access to the fuel pump. Remember to disconnect the battery and follow proper safety precautions before attempting any work on the fuel pump. If you need ...
Question about Peugeot Cars & Trucks
safety seat in a car with or without LATCH points. The Peugeot 406 was required to have LATCH mounting connectors effective in 1999 in the US and Canada. The location of the mounting connectors should
...seat switches function.GM bulletins are intended for use by professional technicians, NOT a "do-it-yourselfer". They are written to inform these technicians of conditions that may occur on some ...
...car's trunk lid release problem. Phase 1: First check the fuse - once you know that's OK, then proceed to phase 2 (below). The fuse for the trunk lock is the bcm (pwr) 15A fuse in the ...
...safety system and prevents you getting a broken neck in a crash. Depress the large button on the head restraint guide and raise the head restraint to the full up position. Depress the smaller button ...
Question about Chrysler Cars & Trucks
...safety. Locate the speed sensor on the transmission. Unplug the electrical connector from the sensor. Use a socket or wrench to remove the bolt holding the sensor in place. Remove the sensor. ...
...car to open the slave bleeder. If you have more questions, please let me know. Bleeding The Hydraulic System Note: brake fluid is corrosive--please wipe any spilled fluid from painted or metal ...
safety boots it can hurt like you know what! Remove the thrust release bearing from the clutch fork in the bell housing and replace it. (Always compare parts making sure that what you intend to fit is
281 questions posted
Usually answered in minutes!
448 Questions
438 Questions
414 Questions
360 Questions
311 Questions