...spout connector location 1989 ford f250 xlt need help locating spout connector for 1989 ford f250 xlt lariat if you look on the distributor you will see the large connector for the mudule bolted to ...
Spout Connector referred to for setting ignition timing? Here is a site to look at, has pictures that may help, also other wriitten directions that tell of other possible locations to find it...http:/
93 ford f250 only fires with the spout connector un pluged no fire when connector is pluged in Check/replace your ignition module.
...spout connector near the distributor to put it to base timing (non computed) Hook the timing light to #5 ignition wire. This will bring the timing mark up. #1 cylinder won't work. Adjust timing to 10 ...
Question about Ford F-250
and fuel pump power is the EEC relay. I would start with checking that. The spout connector should be in the harness near the ignition module. Its a connector with a plug you remove to set base timing
where is the inline spout connector on a 90 ford f250 with a 460 in the wiring run just prior to distributor
SPOUT pin connector. The timing is fine. I plugged the SPOUT back in and observed it. it was jumping around a lot! PLUS! I must mention that when the SPOUT is disconnected, it still runs like **** and
...spout and the filler tube loosen it and work the rubber line off sometimes you may have to get a screw driver being careful not to damage the rubber tube and break the seal where it has stuck to the ...
...spout connector that has to be bridged when setting timing?) rehook the vacuum line to the distributor advance, drive it and set it back not to where it does not knock at all, but to where it barely ...
89 chevy blazer spout connector located where is the spout connector located on my 89 blazer? and also the egr system? Only Ford products used a spout connector during the 1980s and 1990s.
529 questions posted
Usually answered in minutes!
907 Questions
705 Questions
546 Questions
442 Questions
465 Questions