...ranger 250 351 v8 starts up and idels but when u go 2 take off it wants 2 die have 2 keep it rev up so it wont die and no power try putting it under a timing light or turn your idol screw up a ...
...power. Those 2 wires are brake & rear turn signal wires. { The turn signal switch should be in the middle, not right position or left. while checking for power in the last 2 wires. Good Luck ...
...power mirrors on a 2002 ford f-250 super duty you need to remove door trim panel there are (2) 7mm screws that hold panel on .. 1 is behind the lower red light lens and the other is behind switch ...
...2 wires comeing out of dlower motor fond power wire cut spliced in a toggal swich had power at wire harness at swich workes fine not fixed right baffeld help the blower motor control speed module ...
...was located in the fuse box / power distribution box under the hood. There are 1 or 2 of them in there, you should be able to locate the box fairly easily, they are almost always plainly marked. ...
2 2140 Brake Master Cylinder 3 — Manifold Vacuum Source 4 2365 Power Brake Booster Check Valve 5 2005 Power Brake Booster 6 13480 Stoplight Switch 7 2455 Brake Pedal 8 — Fluid Level Indicator (Part of
...2 solenoids. A large one toward the front and a smaller one right behind it. The glow plug relay is the smaller one toward the rear. The larger front one is the intkae heater relay. To test the glow ...
2. As these trucks get older the power steering pumps tend to make lots of noise before they eventually fail. Usually the fluid in these cases is black as night from the pump burning the fluid. If the
...2 inches from where the pedal was. Should the pedal not drop you have a vacuum problem. If you have a hydra-boost brake system this check will not work. A Hydra-boost brake system does not have a ...
529 questions posted
Usually answered in minutes!
907 Questions
705 Questions
546 Questions
442 Questions
465 Questions