2004 Dodge Dakota "timing 3" Questions

3.9 Where is the timing set at usually. To set timing must I take off vac. hoses and plug them. Firing order 1-6-5-4-3-2 ------- front ' 2 4 6 ' of ' 'Distributor rotates clockwise vehicle ' 1 3 5 ' -

...3 times in 60 days. Two new pipes with overheated and then failed and holes blown out. I suspect that it is over fuelling and the cat converter is blocking the exhaust check ignition timing as it is ...

When I fill up my caravan, the pump shuts off after a few seconds and keeps doing that the entire time the car is being filled. It shuts off like it is full, but it isn't. This has happened the last 3

how do you read the codes 2 ways. 1) with a code reader from autozone (they do it for free by the way). and 2) use the cars key by turning the ignition key on and off 3 time and the 3rd time leave it ...

CHECK ENGINE LIGHT FLASHES 10 TIMES TRANSMISSION STAYS IN SECOND GEAR. V6 AUTO. CHECK ENGINE LIGHT FLASHES 10 OR 11 TIMES WHEN CYCLE KEY 3 TIMES Run scanner and computer for test can be MIL see the ...

wheres obdii connector in a 1987 dodge dakota? i can seem to find the OBD2 connector in my 1987 dodge dakota it should have one right? it has the carbed v6 in it No, OBDII started on some 1995 ...

...check to see if spark plugs are firing an receiving fuel If it is cranking faster than normal ( for example, twice to 3 times as fast), you likely have a broken timing belt. God bless your

check engine light comes on flashes 3 times engine running rough, spitting and sputering first you have to diagnose the cause of trouble. How to get the codes on a 1998-1999 Dakota: Depress the trip ...

my truck takes a very long time to start it turns over a lot and finally starts what would be the first and easiest thing to start with to start check the whole fuel system for any leaks,and replace ...

...Timing marks Front of Motor---Cylinders--- 1,2,3,4 Firing Order---1-3-4-2 Clockwise Timing 12 Degrees BTDC Compression 135 # Timing is set with timing light Marks are under trans housing dust ...