2004 Dodge Dakota "high voltage" Questions

Ad

Question about Dodge Dakota

1 Answer

...voltage on blower 12 volt wire 12 volts present. I automatically think, bad ground. I ran temporary body ground to ground wire on blower motor, blower ran high, but would not shut off. I am unable to ...

Ad

Question about Dodge Dakota

1 Answer

VOLTAGE HIGH WHEN MONITORED With the ignition ON and battery voltage above 10.4 volts . SET CONDITION Throttle Position Sensor voltage at the PCM goes above 4.5 volts for 3.2 seconds . POSSIBLE CAUSES

Ad

Question about Dodge Dakota

1 Answer

high to nothing. there is no voltage limiter that i can find . can this be the engine controller gone bad? every other fuction seems normal. code 41 comes up when checked on board. Very will could be,

...voltage too high. The O2 sensor signal voltage should fluctuate under normal conditions. Sounds like it might be your fuel pump, but before I changed that out I would check the electrical connectors ...

...voltage too high or low. Also says probable cause int. tranny failure or open short circuited condition. What does this mean? There is an issue where the oxygen sensor that is after the catalytic ...

...switch is on high it puts a full 12Volts to the blower motor. When you have the switch in any other possition, the voltage is routed through the resistor and reduced thus making the motor run

Question about Dodge Dakota

1 Answer

...there IS a code 46. Battery voltage too high during charging or charging system voltage too low. That would make sense with the 41 code. Sounds like you may have an alternator/charging system

Question about Dodge Dakota

1 Answer

...voltage is present, go to next step. (4) Set wiper/washer switch to HIGH position. Move voltmeter (test lamp) lead from terminal H to terminal L of the wiring harness. If voltage is present, there is ...

Question about Dodge Dakota

1 Answer

...High Voltage (Bank1, Sensor1)This involves the front oxygen sensor on Bank 1. This code indicates that the heated oxygen sensor reading is too high. In the case of Ford vehicles, that indicates the ...

Question about Dodge Dakota

1 Answer

1997dakotafaultcode1763 only when brakes appliedtrans starts in drive your governor pressure sensor voltage is too high need email address to send some images with procedures on how to test it

Not finding what you are looking for?
2004 Dodge Dakota Logo

741 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

2001 Dodge Dakota
2001 Dodge Dakota

1,021 Questions

1998 Dodge Dakota
1998 Dodge Dakota

870 Questions

1997 Dodge Dakota
1997 Dodge Dakota

712 Questions

1995 Dodge Dakota
1995 Dodge Dakota

723 Questions

1992 Dodge Dakota
1992 Dodge Dakota

618 Questions

Top Dodge Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...