...until this happends internaly on its own you may have a liter left after your done ,you can use this for top ups inbetween oil changes .you should also check and replace your air filter at this time
LEAK I have an oil leak with possible antifreeze mix. Does the motor have to be pulled over to get to the oil pan to replace the gasket? Hi,here's a link to show you how to replace your oil pan gasket
oil pan replacement 2007 chevrolet silverado details Rickafix shows how its done on you tube at this link http://youtu.be/g1e3kx3mOMY Oil Pan Gasket Replacement Oil Pump Inlet Tube Ring Replacement ...
Question about Cars & Trucks
...oil pan is busted ...the oil pan cover is hanging off of car and oil is pouring out I checked oil and there is none showing ran over a cone in middle of highway going 50 mph The vehicle is obviously ...
Question about Ford Cars & Trucks
...oil pan gasket for my 1973 ford f350 with the 360 motor in it? every thing, im lacking the confidence. and just needc a lil help Just take off the oil pan (drain the oil first) bolts, remove the pan ...
...Drop Pan, Clean all serfaces, Apply Gasket sealer /Gasket replace bolts tighten to 23 IN pounds/ Add Recommended Oil, Run to Check for Leaks, Probably 1 hour will show any leaks if not done ...
Question about GMC Cars & Trucks
...replace an oil pump on a 2005 Gmc Envoy XUV 4-wheel drive Are you wanting to change the oil pump because the oil pressure flickers while idling after the engine has warmed up? If so change your oil ...
...replace it, screw the cover back on , screw drain plug back in, refill oil , start the car and check for leaks. To reset the "change oil" light, just key the car on and hit the gas peddal 3 times ...
Question about Ford Freestar
Oil Filter Replacement. Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection in Engine Electrical. Found this info in a database. Make sure the instructions
...replace oil pan gasket or get new oversized oil pan nut or use pipe thread on the plug you already have Tightening the bolt is not always the solution. Have you replaced the gasket at any point? I ...
1,030 questions posted
Usually answered in minutes!
1,136 Questions
365 Questions
71 Questions
13 Questions
5 Questions