1999 Dodge Ram "throttle body idle screw 99" Questions

throttle body was gummed up. They cleaned both and it runs fine now clean your iac valve I have 1998 ram 1500 5.2. It shuts off when I take my foot of the gas pedal to stop. Replaced the TPC. ran fine

...throttle body. If you pull the air tube off of the throttle body and look to the rear of the throttle butterflies you will see the passage for the air to flow through to the idle air control motor. ...

...throttle body is a tiny set screw for idle adjustment. sometimes it gets gunked up. remove set screw and using a emory cloth sand edge of set screw. remember to mark where the set screw is before ...

...throttle body with 2 Torx screws (I forget what size) and has a 4 way conncector if memory serves. Take the 2 screws out and it will come right out. Make sure the old o-ring comes off and the new one ...

throttle body intake. Remove the 2 security screws holding it on and then carefully inspect it for a broken filament. If it is not broken gently clean the filament(s) with a qtip and isopropyl alcohol

...idle speed. Loose throttle body or intake creating vacuumleaks. Need to use a scanner to try to pin it down. Dirty or faulty map or maf sensors But I think you'll find rotten rubber vacuum

...THROTTLE BODY COOLANT HOSES DISCONNECT IDLE SPEED CONTROL VALVE CONNECTOR AND DISCONNECT TPS SENSOR CONNECTOR. THEN REMOVE THROTTLE BODY ASSEMBLY. YOU NEED TO BUY NEW THROTTLE BODY COOLANT HOSES AND ...

...the idle air contol valve(IAC). Its located on the throttle body. Air passage breakdown, mounting screws (4) IAC valve (3) O-ring seal (2) on 2000-02 4.8L, 5.3L, 6.0L engines. Other engines

Maria So I guess that would be the same as the Idle Air Control Valve for the 4cylinder If it is a V6, most likely it is the Idle Air Control Module (IAC). It screws into the side of the throttle body

...throttle body, remove wire connector, remove the torx screws that hold it on. when off of car. clean valve on end you can use a old toothbrush or similar to do this. do not push in on valve it will ...