1999 Dodge Ram "oil cap 1500" Questions

Ad

cap off. tank vent system issues, 522 is the one. P0522 Dodge - Engine Oil Pressure Sensor/Switch Circuit Low Voltage the PCM sees no oil pressure and refused to start. sounds like a winner there. huh

Ad

...the oil pressure sensor on a 1999 dodge ram 1500 5.9 gas motor Looking straight at the engine from the front it is located to the left of the distributor cap and directly behind the intake

Ad

Question about Dodge Ram

3 Answers

...cap seems ok)? We are taking it to dealer in a couple days. think it will be safe to run it for a day or two since it is running fine? check the oil and coolant levels. if they are up, and there are ...

...oil, Battery, and distributor. Now the truck wont start. The starter terns but there is no kick. I checked the fuel line and it has fuel plenty of presser. I went back and found the lay out for the ...

...cap and rotor and the cat con. Any suggestions? did u try turning the distributor??? if u did u need to take it to a shop and have the cam sync reset with a scanner,turning the distributor on those ...

...oil level and both were normal so I went to the store. On the way back the transmission dropped into "limp" mode. I drove home and the van sat for about two months. My mechanic friend replaced the ...

...oil discoloration on it.  No change   Checked fuel pressure at 50 psi on rail ok Replace plugs, wires, coil and cap and rotor. No change Noticed dimming of hood courtesy light under load ...

oil cap and no water in the oil. Vehicle runs fine This is very common on the 4.7 Rams, internal moisture collects there and forms a white sludge in the neck and on the cap. I have battled this myself

Question about Dodge Ram

1 Answer

...is located on a dodge ram pick up 3.8 1998 1500 v6 remove oil pan from engine..oil pump is bolted to rear main bearing cap of engine..pickup tube may be plugged if you're having an oil pressure ...

...pick up The oil pump is located inside the oil pan, it is bolted to the center main bearing cap of the crankshaft. To replace it you must raise the engine off the mounts and then remove the oil

Not finding what you are looking for?
1999 Dodge Ram Logo

2,544 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

1994 Dodge Ram
1994 Dodge Ram

197 Questions

2004 Dodge Ram
2004 Dodge Ram

173 Questions

1998 Dodge Ram
1998 Dodge Ram

143 Questions

1990 Dodge Ram
1990 Dodge Ram

114 Questions

Top Dodge Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...