...Idle AIr Control valve; located on the side of the throttle body. I think you have the problem after you disconnect the battery. It is the ECU reseting, it will be ok after few days. If it doesn't ...
Question about Dodge Ram B350
reset. Could be your idle air control valve or motor. The computer controls idle speed through this actuator. Deposits can build up on or around and in the air passages the valve controls, restricting
reset it... but still same problem The item in question is call Idle Air Control (IAC). This unit function is to do fine idle trimming at idle. IAC is located near the end of the accelerator cable. It
Question about Dodge Ram B350
Idle Air Controller; Operation of the throttle mechanism and throttle butterfly (adjust the back-stop if needed); Operation of the Throttle Position Sensor; Check for leaking vacuum hoses or a leaking
Question about Dodge Ram B350
...up, shut it down and let it soak for 30 minutes, restart and blow out the remaining fluid, shut it down and disconnect the negative battery cable for 5 Min's to reset the base idle ...
...reset itself and run fine at other times. need to replace the idle air control motor on the intake. it is sticking because of carbon build up also you may have too take it to a shop with a diagnostic ...
...idle air control locations u'll find it to do this job a shop will charge u anywhere from 100.00 for diag to retrive the code plus the part and the labor so about 250.00-375.00 it will only take u ...
does work. Next time you disconnect the battery, put a charger on the battery terminals as you do it and it will "save" the map info. Turn the motor on and off 3 times to reset electronic idle control
...idle or stopped. When you take your battery out and put a new one in all your computer controls have to be reset. You need to drive the car at 55 MPH for 2 min or so, stop, go through normal drive ...
Question about Dodge Ram B350
...idle.I would take the mass air flow sensor off and clean the thin wires inside it with a non-chlronated brake cleaner then let dry for 15 minutes and re-install.You will need to reset the computer ...
20 questions posted
Usually answered in minutes!
2,271 Questions
2,049 Questions
1,788 Questions
1,616 Questions
1,496 Questions