2004 Dodge Ram 1500 "change bottom radiator hose 2002" Questions

Bottom radiator hose is ice cold. Truck does not overheat. Why no heat? Why was radiator replaced?Did it have heat before ? If it was plugged, the heater core may also be plugged. Try flushing it with

radiator should lift straight out. Check bottom core support and make sure it's straight across. If the bottom core support is bent, this is the best time to get a big ole hammer and straighten it out

...change out radiator and can't find drain plug drain plugs are up in a protected shroud in the bottom tank will require a large phillips driver to undo may have to remove the plastic splash panel ...

Change thermostat? Where is the thermostat located, top or bottom hose? Not sure about this car. However, most times the thermostat is located on the motor where the main radiator hose connects to the

...changed thermostat noticed top hose and engine gets hot and overheats no heat in radiator or bottom hose any possible causes It sounds like either a blocked radiator or cylinder head gasket ...

...CHANGE UPPER RADIATOR HOSE ON 6 CYLINDER 2002 FORD TAURUS Hose clamp the bottom hose before you remove upper is fastest. You loose a bit. Or you can drain rad and clamp lower. Be sure to really clean ...

...bottom hose. The thermostat is located at the upper radiator hose end of the engine. The hose will connect to a housing that will have to be removed in order to change the thermostat. While you have ...

change the thermostat on a 2.7 liter Hi, it is under the housing where the lower radiator hose hooks to the engine. Follow your bottom radiator hose to the side of the motor (right side) there will be

...change radiator fluid every 3-4 years. There are many ways to do this, I frequently will just open the draincock on bottom of radiator, run engine, and allow to drain out with a hose in the radiator ...

...bottom of radiator. remove cap from radiator so coolant will continue to drain and when coolant is down enough to pull off upper radiator hose at intake then close drain, then remove two bolts at ...