1999 Dodge Ram 2500 4WD "abs fuse sensor" Questions

...fuse I could find in the entire vehicle, also, I have researched your problem a bit and have found a couple possible fixes. One is that the abs sensor on the rear differential is known to be sketchy ...

...on a 2000 dodge 2500 van will not shut off abs motor only will stop if i pull the fuse for it no leaks of brake fluid detected...whats next? sensors are in wheel bearings,you may have a bad ...

...abs, brakes, engine light just cmae on and my speed odometer stopped working. I have checked for fuses and that's not the problem. Any ideas? speed sensor prob went bad. it's at the tail end of the ...

...abs and brake lights. Also the Speed odometer is not working There are two sensors that can cause this. One is located on top of the rear axle pumpkin, and the other is either on or inside the trans. ...

...Abs ignition run fuse circuit has no power flowing through it, fuse is good The ABS light on Will Have to be deleted From the ECU Stored fault, regardless of any repairs. The fuse in question is only ...

...ABS fuse it blows agian there is a short in system is the abs or brake light on if bothe are on you may have a shorted wheel speed sensor Abs light on , new sensor and hub fitted, but ABS light stays ...

...ABS notched rotors, and make sure they are not caked up with debris, oil or dirt because the sensors read these notches. The battery light may be on for the following reasons: 1. Alternator faulty - ...

...abs sensor is out, I replaced abs sensor with new ones, but still have same problem. so i checked  for power going back to abs sensor going to housing and have no power. what would  be ...

...fuse for the ABS hydraulic pump and then put it back in and see what happens. Don't ever recall a pump running. Dealer may need to hook up scan tool for diagnostic fault codes, DTCs. Principles of ...

one of them is shorting out, to verify, remove the abs fuse from the fuse box under the hood, test drive the vehicle, it should run fine without the abs system. have these sensors cleaned or replaced