1998 Dodge Ram 3500 2WD "putting spark wire" Questions

...spark plugs out and put the wire on the end and touch it on the motor and have someone start the car and if you see a spark the that is good you might have a couple bad spark plugs you might have a ...

...SPARK PLUG AND PUT A FLAT SCREW DRIVER INSIDE THE WIRE AND PUT IT CLOSE TO THE METAL SO THE WIRE GETS GROUND AND HAVE SOME ONE TO CRANK THE ENGINE AND YOU GOING TO SEE THE SPARK IF YOU DONT SEE SPARK ...

...spark plug wire at a time so you do not cross any of the wires or if you do you will mess up the timing for the envoy now how to remove a spark plug wire, look first at the plug wire and then gentky ...

...spark plug wire put a good spark plug on it and ground it no spark with everything new. Coil is bad inspect for cracks u could check for spark at the coil wire going into the distributer(center wire

spark plug? Bad wire? Rotor / cap new? Check those things out, wear a thick rubber glove, take the wire off the non working plug, put a screwdriver next to the wire (while car is running) and see if a

...tach... go to the positive on coil, and distributor (points, condenser) wires go to negative on coil. What are you working on? a shorted condenser wire or closed gap in points can cause no spark

...spark plug tester, and put it between plug wire and dist, cap. if it is sparking you will see it. if yes and not to plugs put on new plug wires. good-day ! if above checks out. remove dist, cap and ...

spark to arc out of the wire and never get to the spark plug. If I suspect an arc and do not see a physical problem, I wait until nighttime and look under the hood while engine is running...they stick

spark plugs and wires for a 2000 chevy blazer Hi,there is label number on spark plug wires.try to match the same number and replace one spark plug wire and one spark plug at the time!!! good luck!!!!!

...spark plug wire at a time. When pulling the wire from the spark plug. Grab the wire"actually the boot" as close to the spark plug as possible. Twist and pull. Never bend or pull on the wire. Always ...