1998 Dodge Ram 3500 2WD "5 oil exhaust" Questions

Ad

Question about Dodge Ram 3500

1 Answer

...oil cooler lines. 5. Remove the propeller shaft. 6. Remove the starter bolts. 7. Support the starter. 8. Remove the torque converter bolts. 9. Remove the exhaust hanger bolts. 10. Remove the gear ...

Ad

Question about Dodge Ram 3500

2 Answers

...5. Clean the oil pan scraper. Installation Procedure 1. Coat the new oil pan gasket with sealant. Important : Install the oil pan within 5 minutes after applying the liquid gasket to the oil pan. 2. ...

Ad

oil then the 5-6pts I already put in. There's a burnt smelling oil leaking from the exhaust flange. Could the high amount of oil flow into the manifold? Plus changed the exhaust flange gasket.

Question about Dodge Ram 3500

1 Answer

...oil pan 5. Clean pan & surface area. 6. Apply sealer 10mm (0.40 inch) diameter of sealer 7. Position oil pan and hand-tighten the oil pan bolts 8. Start with front of oil pan tighten each bolts ...

oil in my 2001 saab 9-5 turbo it wasn't over heating just smoking bad out of the exhaust check the oil level. Probably not enough oil in the sump because the oil seals in the turbo have failed and the

...Oil Filler Cap 2 6A548 (8 Req'd) Valve Cover Bolt 3 6582 Valve Cover 4 ? Exhaust Manifold Shield-to-Exhaust Manifold Nut (4 Req'd) 5 9A462 Exhaust Manifold Shield 6 ? Exhaust Manifold Shield Stud (4 ...

Question about Dodge Ram 3500

1 Answer

...raise rpms for another 5 mins keep driving smoke will burn off while making other drivers mad. sorry just smile and wave. The engine oil on this vehicle should only be changed by an experinced

5 plugs had oil on the electrodes 2,3,4,5,6 # 1 was ok, #6 had slug on it the other 4 wet looking oil . no air from leak down test in radiator no over hearting oil coolant loss or exhaust, or throttle

...to fix it. Hi , Oil from the ex pipe? Liquid oil or burned oil? The oil may be so new that you are not seeing it on the dip stick? An engine will run about 5 min with no oil before it locks up. ...

Question about Cars & Trucks

1 Answer

...5 to 8 thousands clearance is standard. intake less than exhaust, (exhaust valves run hotter than intakes) If more than that, they will make noise. In rare incidences flat spots wear into a cam and ...

Not finding what you are looking for?
Cars & Trucks Logo

151 questions posted

Ask a Question

Usually answered in minutes!

Top Dodge Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...