2002 Pontiac Grand Prix "headlight bulb replacement" Questions

...headlight bulb Hello, The 2004 grand prix pontiac houses 2 headlight bulbs per headlight assembly. The low beam headlight are located at the fender of the car and the high beam on the grill side of ...

...headlight bulb i JUST GOT HOME FROM THE LOCAL NAPA AUTO PART STORE AND PURCHASED THE HEADLIGHT BULB TO REPLACE IN MY CAR. I LIFTED THE HOOD AND HAD NO CLUE WHERE TO START. I HAVE A 2002 PONTIAC GRAND ...

...bulb(drivers side) on 2005 Pontiac Grand Prix? Upside down L shaped bracket that is bolted to frame just behind headlight assy. Unbolt bracket, lift bracket straight up to unlock headlight assy. ...

...headlight unit, just the bulb. Usually you have to open the hood and you can get to the bulb from that back side of the headlight housing. You give the holder/socket about a 1/4 turn and then pull it ...

Headlight bulb burnt out. Upon replacing bulb, found the plug had been hot and burnt the plastic mold around plug. The prong hole was also black. New replacement bulb also burnt out immediately. ...

headlight bulb Hello, it's easier to change the light bulbs in this car than in a lot of other vehicles. The 2008 pontiac Grand Prix uses separate bulbs for low beams and high beams. The low beams are

how do you replace a headlight switch in a grand prix how do you replace a headlight switch in a 99 grand prix gtp. head lights do not come on. all other lights work. fuses are good. amd so are the ...

Then just twist the plastic cap out of the headlight and replace. (Do not touch the bulb when replacing). Then put headlight back in all the way and slide the plastic retainer clips back into position

...headlight bulb how do u change the headlight bulb on a 2000 pontiac grand prix gtp inside the engine compartment directly behind the headlight it unscrews and pops out. then put it back in and ...

main headlights wont work but bright headlights do To all, check your dim bulbs. Make sure they aren't burnt out. If they aren't, time to see if your dimmer/turn signal switch is the problem. For the ...