...neutral safety switch. Try putting the car in neutral and turning the key. If it starts then I'd investigate the linkage and/or neutral safety switch. Best of luck. Greg Its most definetly the sensor ...
...neutral.Loosen the attaching bolts for the switch.Using the angling pin, move the switch until the pin falls into the hole in its rotor.Tighten the attaching bolts.Recheck the switch for continuity. ...
...into the transaxle case. Attach the electrical connector to the switch. Lower the vehicle. Connect the negative battery cable. Where do I put on the neutral safety switch on a 97 Dodge caravan 4 ...
...put it back It's sounds like the neutral safety switch is bad. When you turn the key to start the power goes from the ignition switch, to the neutral safety switch then, to the starter solenoid. When ...
Question about Pontiac Firebird
...Neutral safety switch is usually located under the shift console by the shift lever. your neutral safety switch is located left rear of transmission. Its directly below shift lever in a module called ...
Question about Pontiac Firebird
...put it in neutral then try to start it..It starts .. What is the problem with my baby....... Test/Service/Replace The circuit on newer cars with automatic transmissions has a neutral safety, or ...
Question about Cars & Trucks
Wiring on neutral safety switch for 87fleetwood cadallic.also can i bypass the neutral safety switch Its cheap justa put a newone in there...u put the brake on anyway w out the switch for safety
...neutral and starting then back to park. Or you have funky aftermarket alarm that is disabling starter. Also if car was financed thru small car dealership they may have put gps with starter disable on ...
...put in for the automatic transmission. Now, I need to wire up the neutral safety switch on the Hurst shifter but I can't find the 2 wires I need and there is no neutral safety switch on on the ...
...neutral. Loosen the attaching bolts for the switch. Using the angling pin, move the switch until the pin falls into the hole in its rotor. Tighten the attaching bolts. Recheck the switch for ...
398 questions posted
Usually answered in minutes!
251 Questions
213 Questions
190 Questions
207 Questions
177 Questions