2000 Nissan Sentra "remove fuel line pump" Questions

...remove the fuel filler cap at relieve the pressure in the fuel tank. 4. Remove the rear seat cushion. 5. Remove the inspection hole cover located under the rear seat cushion by rotating the attaching ...

fuel system. Remove or disconnect the following: NOTE When the fuel sending unit needs to be removed, pull the tab upwards. The tab is located on the sending unit, opposite the end of the float. After

...remove fuel line quick connector carefully (if pressure was not relieved, gas will leak, make sure to release pressure completely), take out fuel assembly (watch out for fuel level sensor and temp ...

...cover aside. Pinch fuel line clip and remove fuel line. Remove 6 bolts (8 mm) and retaining ring comes off. Pump can now be removed. Installation is reverse of removal. Pump is spring loaded a

...remove that, then disconnect the fuel lines and 2 plugs 1 is for your sending unit (fuel level and low fuel light) and the other is for the pump itself. after removing those there is 8 8MM bolts that ...

fuel return.If its plugged you can not get the air out of the lines.Remove the the line and blow through it If you cant its clogged.Also you can prime the line line by turning your key on and off .You

...and out the rear. The fuel pump is held in with a loc-ring, you can use a screw driver to turn half way to remove, then the assy. will come out. this is a 2 person job on the ground, and be

...Remove the fuel line coupling and then the 6 screws holding the inspection cover on. BE CAREFUL not to bend the level sending arm. If you remove the fuel filter, make sure you mark which way it came ...

...fuel tank there is filter remove the screws on the top where the fuel gauge fitted when you remove gauge you can see fillter that is one sometimes blocked. Next if you check fuel filter it is ok, but ...

...fuel pump on my fiero I had to bleed the line by removing the valve stem and put a piece of hose over the valve and into a approved fuel can. I then had someone crank it while i was holing the hose ...