2006 Ford Ranger "4 right side oil" Questions

...4 pints). Turn the engine on the starter again for a minute or two with the plugs out. This will allow the oil to help flush any water from the passageways. Remove and discard this flushing oil and ...

...4 smaller gears in the center) remove bolt and slide out the pin be careful not to drop the gears once the pin is out push in on the right side axle shaft there is a "C" clip on the end of the axle ...

...right (passenger side) of 4 cyl. engine after car is parked. Oil splatter all over right side of engine. Where could the leak be from? May be related: The right side squeaks when the wheel rotates. ...

...4-2-5-3-6 Good luck if you are over the right fender its the first spark plug in the back wish you the best of luck Michigan Man. loosing oil under rt/side under the power sterring pully/waterpump ...

...right center of engine compartment. find your oil filler cap and look lower. its a black oil filter housing. 1"1/4 socket fits it or your can get a special socket for this housing at oriellys for ...

4 10mm bolts 1 is hidden Lower right side Pump front now your oil pump will be loose to remove off pull forward to front of truck....I find that pouring Lucas engine oil stabalizer into the pump where

...4 cyl. How the heck do you find the oil filter? I know about where it is but don't see it and can't feel it. The oil filter is located just in front of the right side drive axle. (Passenger side) It ...

...right side of intake manifold. Use a 32 mm (1 1/4 in) socket on the hex on top of the oil filter cap, or an oil filter wrench on the outside diameter of the oil filter cap. Remove the oil filter cap ...

...at the lowest back side of the oil pan and on top of the car the oil filter is about 6 inches forward and right of the oil filler cap and is a black plastic cap with a hex head measuring 1 1/4" ...

...4 cup oil across paper on right side. good engineering practice dictates that the head should be skimmed flat and new head studs used further more the stud holes should be cleaned with a thread tap ...