2004 Ford Freestar "remove air bag controll module" Questions

Remove the air inlet door motor mounting screws. CAUTION Do not attempt to bend any part of the air inlet duct door lever. Rotate and remove the air inlet door vacuum control motor. To Install: Rotate

...Remove the air bag control module. Remove the three bolts. -------------------------------------------------------------------------------------------- driver air bag module Disconnect the battery ...

...air bag light would go off? Yes!!! You can replace it yourself.(Dont let others fool you into paying extra or telling you otherwise.) -This is for pontiac grand ams 1999-2005 only. -There are no ...

...remove the air bag fuse.Do not remove or disconnect anything in the air bag system for at least a half hr.This system can go off for up to 15 to 20 minutes after power is removed.You also have to ...

...Air Bag Issue I recently had to remove the dash from the car. Following reassy the SRS light flashed continuously. It stored the code B1073. I attempted to reset the SRS controller. Finally all codes ...

air bag module out and remove it. WARNING Do not handle the passenger air bag module by grabbing the edges of the deployment doors. Remove the defroster opening grill. Fig. Defroster grill view Detach

Remove the air bag module retaining nuts from behind the steering wheel. Remove the air bag module. If equipped, remove the cruise control switch. Disconnect the horn wiring. Remove the steering wheel

...Remove the air bag retaining bolts and... Fig. 3: Carefully remove the air bag from the steering wheel to access the wiring connectors Fig. 4: Detach the connectors... Fig. 5: ... from the air bag ...

...Remove the driver air bag module. Release the two retaining tabs. Disconnect the driver air bag module electrical connector. Label the driver air bag module squib number on the driver air bag module ...

air bag module bracket. Remove the powertrain control module (PCM) electrical connector bolt. Pull the connector from the PCM and position aside. Remove the two PCM bolts. Remove the PCM relay. Remove