2001 Ford Focus "power fuel pump" Questions

...the key is turned on then you will have to replace the pump and i would also replace the fuel filter.If you do not have power at the pump then it has to be a blown fuel pump fuse or fuel pump

...pump is opening to recieve fuel,problem started with a total loss of power on idle,then managed to get power but only above 3000 rpm,won't go at all now just fit a new fuel pump ,its in the sender ...

...power wire to my fuel pump i need to jump my fuel pump so i can pump the bad gas out put i dont no what wire to hook a hot wire to so i dont need to sit there and turn the key on and off Remove the ...

...power getting through,check the fuel pump motor is working.If so check the fuel is running through lines freely.If not getting through the fuel lines or filters may be blocked.If the fuel is running ...

...power and there is poor acceleration. fuel pump may be going out stand by the end of the car and try to ear the pump making sounds if it dosen't make any sounds then it bad hope this info helps the ...

...fuel pump is supplied by the power relay or FPDM power supply relay. (For additional information on FPDM operation, refer to PCM Outputs?Fuel Pump and PCM Inputs?FPM.) The fuel rail pressure (FRP) ...

...run a fuel pressure test, and check the fuel pump relay, in the underhood power distribution box, if relay is good and you have power at the pump with no fuel pressure then you have a bad ...

power going up hills had a diagnostic done no faults showing no warning lights on what could it be try the fuel filter first - fuel pumps usually either run or they don't - no intermittent sputtering

...fuel pump is suspected, a good technician will always check to verify there is power and ground being supplied to the pump, to eliminate the possibility of a bad relay or electrical issue. Fuel ...

...fuel pump and changed the filter. Theres spark at the plugs. It just doesnt seem to want to do anything. The engine turns over fine do you have power to the pump ?? if power to pump then pump needs ...