2010 Ford Fusion has intermiitant clicking sound near the left side of the dashboard/steering window. Sound occurs when engine is on, while driving or in park. Sounds like electrical wires arcing?? ...
Question about Ford Focus
...2010 journey make a chirping noise from left side of vehicle, i replaced the wheel bearing hub but it was'nt it, any ideas, when i apply brakes the noise quits for a few seconds. Sounds like brake ...
Question about Ford Focus
2010 chevy Equinox LT Left rear wheel is locked. Could the parking brake be stuck on? No warning indicators on. Locked while driving up our driveway. Came unlocked and seemed fine eventually but when ...
Question about Ford Focus
2010 Elantra, started with a high pitched sound turning left. Did that for a few days, then started when turning right. Now same noise is cooming for about 10 seconds. Not immediately on start up but ...
Question about Volkswagen Cars & Trucks
...2010 volks wagon jetta has turn signal problem when i put the blinker in nuetral position left blinker comes on when i put it in left position it turns off right position works normally with turn ...
Question about Ford Focus
2010 gmc has a misfire code and pinging sound what could it be A misfire code is either plugs or injectors but if you are getting detonation (pinging sound ) then it may be faulty injectors letting in
Question about Ford Focus
...2010 kms 196500-problem is that only one vent (left most) is having hot air other three vents are giving out cool air?please reply at [email protected] Sounds like you have a duct that came ...
...2010 I hear a short whistle sound while press a sudden press on the accelerator (Not the normal Turbo charger sound), VW dealer confirmed requested to change the water pump which solved problem and ...
Question about Ford Focus
...2010 Corolla and it will not start. I had the battery tested and that is good- nothing comes on when you turn the key, it just clicks. The battery cables are clean, we have checked all of the fuses. ...
LEFT FOR AN HOUR MY 2010 SPRINTER TAKES A LOT OF CRANKING BEFORE IT STARTS. WHEN IT HAS BEEN RUNNING THERES NO PROBLEM UNTIL I LEAVE IT FOR AN HOUR IT WONT START AGAIN SOMENE SAID IT COULD BE THE FUEL
3,753 questions posted
Usually answered in minutes!
3,749 Questions
2,055 Questions
1,226 Questions
897 Questions
840 Questions