...01.Raise and support the vehicle. For additional information, refer to Section 100-02.Detach the intake manifold bracket. Loosen the nuts and remove the bolts.Lower the vehicle.Remove the air cleaner ...
Question about Ford Focus
...brake master full of fluid.I clutch master or clutch slave cylinder bad? Vehicle with 2.0L engine Remove the air cleaner. Disconnect the electrical connector at the mass air flow (MAF) sensor. Detach ...
...brake cleaner 01:07 Set the emergency brake and make sure car is on level ground. 01:13 Remove the lug nuts and tire. 01:20 The part on top of the brakes is the brake caliper. 01:25 Using a 12mm ...
Question about Cars & Trucks
...wheels spin but car will not move on an 01 olds alero Have to ask.. Bald tires? if not look at the brakes. Brake hoses clogged from the inside and keep the brakes tight. Calipers can also do
Question about Cars & Trucks
...01 f -150. the brake pedal went all the way down, and the engine went on high rpm, but the pedal got hard , and then got normal again. My question is what can it be? thanks .. Check your brake fluid ...
brakes grab on 01 express van new parts replaced still grab ergh replaced rotors pads,bearings hoses whats next? drum brakes i assume and when you say grabbing.. when you hit the breaks the back pulls
...01 when using brakes or idoling alot in traffic, car starts overheating. when I am not on the brake temperature needle come back down to the middle. where it should be. Comment by valeriek, posted on ...
01 Jeep Grand Cherokee - 6 cylynder I'v tried 3/4'', 11/16'', 12 mm - always slips off What is your question? You have metric tools. Are you missing a size ? Which nut? Caliper mount or brake hose. Or
Question about Cars & Trucks
...01 VW Jetta Wolfsburg. While waiting in a drive through I had a steam come from drivers side hood and wheel. Then a high pitch whistle. Brake light came on and beeping. Still have brakes. did you ...
01 Grand Cherokee To install: Position the brake pads onto the caliper. Position the caliper into place on the anchor. Coat the caliper slide pins with silicone grease and torque them to 21-30 ft. lbs
3,753 questions posted
Usually answered in minutes!
3,749 Questions
2,055 Questions
1,226 Questions
897 Questions
840 Questions
