...upper and lower ball-joints, rust can make the steering hard on any vehicle. If you decide to change out the pump, check whether the new pump comes with the pulley. Some of the pulleys require a ...
...upper and lower unbolt it and get hold of a "PICKLE-FORK" to drive the 2 pieces apart,they sell them at most auto parts outlets It's a bit of a job especially if you live in the north where road salt ...
...upper, lower balljoints and stearing components like tie rod ends, also the factory steering dampner may need replacing. also the mass air flow sensor would make the truck run rough but would have ...
Question about Cars & Trucks
...upper mounts;sway bar bushings & links;lower control arms with ball joints& passenger side upper motor mount.none of these have changed this noise even s Have replaced all tie rods; ...
...lower or upper ball-joint, lower ball-joint, nor tie-rod end. A lower ball-joint being bad, would make the front-end shake. Upper ball-joint, and tie rod ends being bad, would make steering erratic. ...
THE TIE ROD ENDS.YOU NEED A HAYNES REPAIR MANUAL TO GET THE TORQUE SPECS.YOU PROBABLY NEED WHEEL ALIGNMENT WHENEVER YOU REMOVE TIE ROD ENDS OR UPPER AND LOWER BALL JOINTS IT WILL ALTER WHEEL ALIGNMENT
but remember when you change tie rods YOU must have vehicle taken to get Re-Alignment....also remember to lube all front end bushings,ball joints upper and lower,also check wear and tear on them too!!
...Upper and lower ball joint torque specs, outer tie rods and wheel hub assembly also please. • Axle Shaft nut - 177 ft-lb • Hub and bearing assembly to steering knuckle bolts - 133 ft-lb 2003 chevy ...
Question about Cars & Trucks
...replace if damaged or worn ---remove wheel and inspect the joints and tie rods if their was no noise or worn check the upper and lower control arm bushings as well as the swaybar supports and ...
...upper and lower ball joint and tie-rod end need to come out, so, unscew the tie-rod end first and seperate it with ball joint seperator. do the same for the upper and lower ball joints. seperate the ...
544 questions posted
Usually answered in minutes!
907 Questions
705 Questions
546 Questions
442 Questions
465 Questions