1994 Ford Bronco "ignition coil" Questions

...coil 6v. i recently replace the ignition control modual 2 weeks ago any ideas??? Ignition control module? There is a IDM , this module,trouble shoot this one instead. PCM uses IDM with the spout to ...

...ignition module, coil has voltage, 12 to negative, 12 to power side when key is rolled but no fire out. 3 coils, switched,? Lost? Could it be the brain, or is it something to do with the fuel relay? ...

...order and it is correct but the truck still wont start well if it started before then the distributor is most likely good but check your ignition coil and also you ignition module also the pickup ...

...link white/light blue wire to ignition coil and eec distributer module. the no. 1 yellow wire at the eec power relay should have voltage on it at all times, it also has a fusible link. good

...ignition coil it was good but my plugs still dont have no spark? A coil can test good and still be bad. Also fuel injected cars have a crank sensor that is the first link that needs to work to tell ...

...ignition coil, checked alternator, i have gas new key turn over new belt, all fuses are good Did you check primary voltage to ignition coil? red wire with lite green tracer, use a test lite to check ...

ignition module has enough voltage to work with. also you can check voltage at coil during cranking to see- you need to be above about 7 volts or so. Also little known fact, if you have stater sol. on

has no spark try changing the ignition module bad coil or pick up coil in distributor new distribiter still no spark

coil gets a ground signal from the ignition module which gets a signal from the distributor.If you have voltage on the positive side of the coil you should also have a ground signal from the module on

...coil and i tested it on another vehicle to make sure it works. Truck turns over fine but no output from coil.Where do I go from here? If there is no power you are describing a faulty ignition ...