1993 Ford F150 SuperCab "adjust throttle cable 93" Questions

...ADJUST THE IDLE SCREW TO RAISE IDLE! IT WILL BE A SMALL SCREW LOCATED BEHIND THE THROTTLE PLATE! ON FUEL INJECTED MOTOR, IT IS LOCATED UNDER THE COVER WHERE THE THROTTLE CABLE GOES INTO! YOU WILL SEE ...

...throttle cable attaches to the throttle,and where the throttle sets,there might be a screw with a lock nut,and will allow some setting,but not much,cause the throttle position sensor does this threw ...

...transmission shifts hard It sounds like you have to much throttle pressure. If your trans. is electronically controlled it could be the speed sensor, if not then check the throttle cable

93 auto? My helper installed the flex plate. Not sure if it was done right. Engine starts but scraping sound coming from tranny area. it will fit with problem. could have put the flex plate backwards.

throttle cable to see if it is to tight. there should be an adjustable stop on the cable . If you mash the gas pedal to the floor it will not shift until it hits a certain RPM. Which is probably a lot

throttle cable , then look to the other side of it. it should have 3 wires and its hooked to the throttle flap so when u open it it can tell the compuuter how far. look good before u remove it because

...cruise control. Confirm its the throttle body by pulling the strongs and reving the engine. There should be a screw adjustment that the actuator rests on. To raise and lower the idle adjust the

...adjust it idk what that part is. any ideas or suggestions THE TV CABLE RUNS FROM INTAKE ATOP OF ENGINE TO THE TRANSMISSION HONESTLY I BELIEVE YOUR 3RD GEAR BANDS ARE WORN OUT (TV STANDS FOR THROTTLE ...

...adjust the bolt in to tighten belt. Its on top of the trans under gear shift but I think u have either a sensor thats bad or possibly internal in the trans a map sensor, throttle sensor, or mass air ...

...throttle pedal is pushed harder? I'm not aware of the typical layout of the Saab, so while these things below are what I would suggest you look at... Not all will apply. Note that if the clutch plate ...