...5:00 o'clock position. The crankshaft should be at TDC (top dead center). There is a mark on the crank pulley and you have to use the timing cover as the other reference to line up TDC. The timing ...
timing chain to align with the marks on the gears. You just have to rotate the engine to where the copper chain link is up on the upper right side of the intake can gear--aligned to the INT diamond on
Question about Dodge Cars & Trucks
...timing marks supposed to stay aligned as long as the engine is on top dead center. After setting timing properly marks are off within 5 minutes of running. ????? If the engine wont run then it might ...
...timing marks line up with the little marks on the engine. Release the tension on the timing belt, remove the belt, put the new belt on, let the tension go back onto the belt, ensure that neither cam ...
Question about Ford Ranger
...5.2 liter its in the FSM. want to read that for free. see chapter marked ENGINE> chapter 9 ZJ jeep it is. there is no such thing, sorry here ill paste the install push rods/rockers. lines (1) ...
Question about Ford Ranger
...5 rotor turn counter clock ward if you pull the cap off you see the rotor line up the timing mark on the crankshaft pulley to the pointer on the belt cover the zero mark is the farthest one to the ...
...much oil goes in 1988 Toyota 4Runner SR5 V6? Start with 4.5 quarts, then check the dipstick. Keep adding 1/2 quart at a time until the level is between the low, and full mark on the dipstick. 5
...until the timing tab "0" mark and vibration damper mark are again in alignment. This is the number four firing position. The following valves may be adjusted: Exhaust: 4, 5, 6 Intake: 2, 3, ...
...5 minutes check oil level on dip stick add half liter at a time and check oil level again wait few minutes in between for oil to drop down in oil pan for proper readings on dip stick.repeat ontil oil ...
...the ignition timing with a timing light. If the marks are not aligned, loosen the distributor bolt and turn the distributor to make the adjustment. The ignition timing should be between 13°-17°
1,000 questions posted
Usually answered in minutes!
645 Questions
573 Questions
562 Questions
558 Questions
477 Questions