2002 Dodge Intrepid "removeing inner tie rod" Questions

...the outer tie rod end nut that is connected to inner tie rod. Pull tie rod end back out of knuckle. Use pliers or vise grips to hold inner tie rod end while turning outer tie rod end to the

...inner tie rod Does anyone know what size socket is needed to remove the bolt and also what the torque is? Thanks, Troy To Steering Gear Bolt 90 Nm (66 ft. lbs.) Jam Nut 75 Nm (55 ft. lbs.) NUMBER: ...

...inner tie rod ends. Loosen both. Remove one at a time, replace bushing with kit. Use some synthetic brake grease on the bushings. I recommend Napa sylglide. Replace the bolt, but do not tighten all ...

...inner tie rod on a 2000 dodge intrepid I did this on a 2002 Intrepid, and found that it wasn't too complicated. I replaced the bushings only, rather than the tie rod end. You can get bushing ...

How in Gods name do you remove the bolts that hold the inner tie rod to the steering rack on a 1997 Dodge Intrepid??? use puller

...inner tie rod bushings on my wife's 97 intrepid. I can't seem to get a wrench onto the nuts to remove the old ones as there is too much stuff in the way. What is the easiest way to do this without ...

...inner tie rod ends as well? Power Steering Rack -I don't think you need to replace the inner tie rod ends as well unless they have excessive play. REMOVAL & INSTALLATION The power steering gear ...

...inner tie rod tool but here are the directions. 1. Break the jam nut on inner tie rod to outer loose. 2. Remove nut from outer tie rod attaching it to steering knuckle. 3. Use hammer to get tie rod ...

...inner tie rods on a1995 honda odyssey?,if so simply explain,THANKS EXPLAIN THE PROCEDURE AND WHAT TOOL OR TOOLS NEEDED. Procedure on replacing the inner tie rod ends:1) Raise and safely support the ...

...inner tie rod on a 1998 ford ranger two wheel drive , driver side . engine size is 2.5. do i have to take outer tie rod off as well? webbraymond2, Yes, you have to remove the outer tie to access the ...