install a Break Controller on in. I have already put the Y connector for the 4 pin harness on, and then installed the 7 pin kit to that. It left me with the wires for a Break controller at the rear of
Wiring for Trailer I just installed a trailer hitch on my 2004 Dodge Durango but I cannot find the wiring. Where is it normally located? The owner's manual said in the rear under the body. ??? its ...
...axle to come out. Once out, a bearing puller is needed to remove the old bearing, and a bearing installed may be needed to drive in the new one. If this sounds out of your comfort zone, a shop ...
I have a 1999 dodge durango, I just had new transmission installed, front and rear brakes installed and rear bearings installed. However the brake light is on, the ABS light is on, the speed odometor ...
wire for the brake lights. They came with factory installed towing harnesses. No need to install aftermarket stuff. The harness is in the left(driver side} rear panel. All you need to do is plug it in
...rear main bearing cap. INSTALLATION Install oil pump. During installation slowly rotate pump body to ensure driveshaft-to-pump rotor shaft engagement. Hold the oil pump base flush against mating ...
...rear. This is the pin that holds the axlesin place. After removing the wheel on the failed bearing side, remove the brake drum if it has one or if it is disk brakes stop there. Remove the 5/16 pin ...
...was making noise on deceleration previous to break. There are supposed to be 2 c-clips on the u-joint caps that keep it from moving in the rear yoke. Did you install a new u-joint and forget
1,424 questions posted
Usually answered in minutes!
2,049 Questions
1,616 Questions
1,378 Questions
1,005 Questions
766 Questions