...cover. I just unbolt the upper intake just enough to lift it up a little. unbolt the cam sensor, pull it out and install the new one keeping pressure on it until it's bolted in. I hope this ...
...OF THE CAM SENSOR AND CRANK SENSOR ON MY 1999 DODGE INTREPID 2.7 LITER Cam sensor is right in front under the planum and crank sensor is by the crank harmonic balancer pully. But why do you
Question about Dodge Intrepid
cam sensor and crank sensors located on my car? I need a diagram showing where the cam sensor and crank sensors are located on a 1994 Dodge Intrepid 3.5l!? Crank Sensor: Passenger side of transmission
...you have. The cam sensor is located on the left cylinder head. The crank sensor is on the right side of the block. The location will vary alittle with the 2.7 or the 3.2, but in the same general
replacement of cam position sensor need to know the location on the engine of the cam position sensor for replacement. driver side front of engine
...sensors where is it? the cam sensor In my 3.5L HO cps is located front top left, just under edge of upper intake manifold, maybe an inch and a half aft of timing cover. I replaced mine, easy
Cam sensor trying to locate the cam sensor on my 2003 Dodge Intrepid. it's a 3.5 V6 On front of the timing covers...
Cam position sensor? You didn't state what engine you have. If you have the 2.7 L, the cam position sensor is bolted right to the front of the left cylinder head. Disconnect the wire, remove the bolt,
cam sensor, how do i feplace it... Bad cam sensor how do i feplace it On the 2.7L V6, it is on the front of the left cylinder head, just below the valve cover. One bolt holds it in position, and there
...where yours is on a 3.5 look on passenger side just below the air duct.I pulled mine from the bottom of my car.it looks similar to the cam sensor located at driverside on top of the timing belt
559 questions posted
Usually answered in minutes!
1,166 Questions
867 Questions
924 Questions
766 Questions
627 Questions