1989 Dodge Ramcharger "little pumpkins" Questions

...nearly no effort. Thanks! Did you turn the bearing adjusters on the ends? They are held still with little

2001 Dodge van 3500 losing fluid but can't tell where fluid is leaking very little pedal,trying to find out where fluid id going Try looking above the rear pumpkin there is a tee that sometimes rusts ...

...it off.Clean the old gasket off both the cover plate and the pumpkin itself. I like to spray a little brake clean to get real clean. Put the new gasket on and snug all the bolts on in a ...

...axle inside the pumpkin make sure everything is tight the check your axle bearings there should be little or no ...

...rear axle pumpkin. A carrier bearing is the round thing about half way between these two. Just a little more information. The carrier bearing is found roughly about the place where the back of the ...

...off you put a new nut on with one of those fast clips i forgot what there called but there is a little hole drilled on axle to keep nut from moving and it looks like a bobby pin can slide in

...a 2007 Honda Ridgeline Pickup truck. Drive the vehicle for about 1 minute to warm up the fluid a little. Locate the 'pumpkin' on the rear axle. It is in the center of the axle. Now locate the two ...

...that is not ingaging. This is located at the pumpkin part of the axle where the gears are. Just a little plastic over with two 10m bolts holding it remove it and the switch will be right there. ...

...off For the most part there is a drum spreader that must be backed off, if there is,you will see a little rubber plug on the shoe plate, looking at brake from pumpkin, a little flat pry bar goes

...get detailed instructions. If you have never replaced gears in a pumpkin before you probably have little chance of doing it yourself. Pulling out your reciever and replacing the bearings and the ...