1983 Dodge Ramcharger "replace 2 wire dimmer switch" Questions

...2 to new switch, for tail lights. new wire to both rear tail lights. Bare two wires shorted from dimmer/light switch, because I still had dash lights. Want to take out, bypass light/ dimmer switch, ...

...staying on. That function is controlled by the headlight switch. Make sure the wires going to it are in the correct location. Sounds to me like you have 2 wires crossed. (dimmer working

...2. take off locking plate with two screwdrivers 3. remove locking plate 4. remove retaing screws and take out turn signal lever 5remove screws from hazzard switch (3) 6.take off panel under the dash ...

...2 ton. the headlights dont work just the running lights work when i pull the light switch out. i bought new headlights nothing some times when the dimmer switch on the floor goes bad the headlights ...

...dimmer switch, look for bare wires, remove the trim below the column, remove the clip for the shifter indicator & remove the 2 bolts holding the column up, this will give better view of the ...

...2 Turn ON the parklamps. Ensure the panel dimmer switch is at maximum illumination. Do the illumination lamps operate normally? YES - Go to Testing for Electrical Intermittents in Wiring Systems NO - ...

...replace it? Thanx possibility of a dimmer switch malfunction, did you check all the fuses under the dash and also under the hood. check thuroughly because you might have missed one. And where your ...

...2 Turn the ignition to the OFF position. Turn the headlamp switch to the HEAD position. Place the headlamp dimmer switch in the high beam position. Are the high beam headlamps operating properly? Go ...

...2 HOLES IN IT. IT WAS FULL OF WATER WHEN WE REPLACED THE BULB. CAN YOU HELP ME?? if it has water/ holes in it, it needs to be replaced. Did you verify voltage to it? ORANGE wire, Ck the EXT LTS ...

2 Disconnect the lamp control module (LCM) connector C1. Connect a DMM from the LCM connector C1 cavity E (RED) to ground. Is the voltage within the specified range? 10-15V Go to Step 3 yes Go to Step