distributer back in exactly like it came out...i had marked it before disassembly. Now the truck runs but stalls when idling and is hard to start. It is a 96 nissan pick-up with a 2.4. Any suggestions
...pick-up with a KA24 engine, It will turn over but it wont start. I have put in a new Distributer and plugs, and I am getting fire to the wires. What am I mising? Even when I pour gas into the throtle ...
...distributer cap?? Don't go by the info. on category ie; 83' Dodge Pick-up is incorrect, I only put that info. for lack of a proper category. 72' Winnebago Indian is correct. Thanks. You can get this ...
for a mass of wires, also look for the old type distributer cap if you don"t see it then you have computer controlled ignition. I can say with almost 100% you do have a computer in your toyota pick up
Pick up with a 22R engine with electronic ignition. So I might not have the specifics for your vehicle but I would suggest that you set your point gaps to the specific gap the manufacturer suggest for
1991 Toyota Pickup 22RE. Loss in oil pressure, timing chain is really got a lot of slack in it. Got 197,000 miles on it. What might be the solution of fixing? The soulution is probably going to be ...
...up with demandSpark plugs.Wires cap and rotorTiming light tune upCheck the mechanical and vacuum distributer timing advance. I would also recommend having a good auto service manual such as a ...
...all. I changed the fuel filter. I have changed the wire from coil module to distributer cap. Changed distributer cap and rotter. change the pick up coil inside the distributer under the rotor
pick up the distributer position rotor? If so my igniter is not magnetic with power off. I can slide a .8mm steel feeler gauge between the distributer position rotor and the igniter/module gap with no
192 questions posted
Usually answered in minutes!
143 Questions
63 Questions
53 Questions
51 Questions
28 Questions
