2001 Dodge Ram 3500 Truck "stuck intermediate" Questions

Ad

...stuck on removing the right intermediate axle shaft. It's a 2003 Ford Escape. i can only guess it is a 3.0l 4v well as far as the axle goes, the rh outer half shaft seperates at the splines on the ...

Ad

...button or remote, but neither outside or inside handles engage Sounds like the latch is stuck in the intermediate position. the actuator or latch probably needs replaced. Go to the dealer on this

Ad

...intermediate working, new brakes. Engine, ABS, and brake lights still on after resetting computer and driving a few miles. P0573 is for your brake switch stuck. It means you either have a bad brake ...

Question about Dodge Ram 3500

1 Answer

intermediate shaft and tap on the bar to uncouple them. Remove the hub locknut and discard. Pull outward on the hub/knuckle assembly, push the outer CV-joint stub shaft through the hub, and remove the

...Stuck. Replaced solenoid and problem is still there. What could be causing my delayed shifting with overdrive light blinking? please change the intermediate band, its a piece like a belt, may be ...

Question about Dodge Ram 3500

1 Answer

...intermediate... usually, check engine light goes off after a few days, and it acts normal again.What is going on?. That's a code for Torque converter clutch (TCC) solenoid-stuck on.......it's ...

...stuck .governor valve sticking .intermediate servo piston seal leaking .2 -3 accumulator piston and seal leaking and worn apply band.try high mileage transmission fluid.made by havoline.it condition ...

Question about Dodge Ram 3500

1 Answer

...intermediate problem but is now pretty much stuck. How is the blend door actuated. How difficult is the blend to access to repair? I have a similar issue - though the vent air is diverted to the ...

...intermediate tank (between radiator and additional tank) cap went off and the radiator coolant water was spilt over the hot engine and created steam. Most overheating problems are caused by a stuck ...

Question about Dodge Ram 3500

1 Answer

intermediate problem but is now pretty much stuck. How is the blend door actuated. How difficult is the blend to access to repair? The bleed door controls air temp not where it comes out, dash, floor,

Not finding what you are looking for?
Cars & Trucks Logo

263 questions posted

Ask a Question

Usually answered in minutes!

Top Dodge Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...