Question about Nissan Sentra
...shuts down)when i would press the clutch in. Now it will run fine in the morning start up but after awhile of driving it will either shut itself off or wont start back up after i turn it off and try ...
...down though. Took it to nissan cause it got worse, they said it was head gasket. They said the original ones were crappy. They repair like 3 sentras a week for head gasket but still no recall. Cost ...
...fine vehicle shuts down while driving down road and does not start backup for at least 20 minutes, could be a bad crank sensor. if bad it will start and run fine, but it will keep shutting down until ...
runs fine shut of wont start then starts up runs fine check the basics, air, fuel, spark one at a time, check fuel pressure and spark, you are losing one of the three for it to shut down, one thing to
Question about Nissan Sentra
runs fine until i go to town then just shuts down but will crank over and fuel is getting to it lwt idle till gets wormed up good go back and forward in drivew few times turn off while doing this test
Question about Nissan Sentra
95 gmc runs fine till i shut it off then wont start till its cool 1995 gmc 1ton runs fine till i shut it off then wont start till it cools down sounds like a crank shaft sensor
let it set for a day it may start and when it runs, it runs fine. However, it only runs for abut .2 of a mile and shuts off and then nothing, again no crank. Ignition switch is the most likely culprit
Question about Nissan Sentra
...runs another 20 - 30 minutes and shuts down. No other problems. Everything else works fine. I'd suggest the ignition control module, however I'd have a certified mechanic check it out just in case... ...
Question about Nissan Sentra
fine all of Outside temperature affects how long it will run before it shuts down. All gauges and power to the engine first sputter then die. Radio and lights work fine all of the time. I can lift the
...down will run less than 1 min and die . will start and run fine later and days later problem will reocure. If you have a solder iron you can open up the relay can and re-solder the relay on the pcb. ...
935 questions posted
Usually answered in minutes!
798 Questions
708 Questions
716 Questions
508 Questions
442 Questions