bus The reset switch is under the dash, on the plastic panel by the passenger door. The panel says "fuel reset", pointing to a hole. Reach in and press down the reset button/switch.It will get reset.
...dash indicators light as normal except odometer says "No Bus." Hi, if odometer say no bus you are loosing your bus signal some were ,with out a bus signal the car not going to run the bus ...
...Bus on dash My dome light, radio, power locks, and power truck (button on dash) is not working. And "No Bus" is on the dash. I checked the fuses and they look good. My car got rear ended and the shop ...
...ten mints later why is that No bus means the engine computer, body computer, and dash panel are not talking to each other. It could be a wiring problem or a circuit board in one of the
Question about Ford Econoline
...dash board no bus or no bu5 remote didn't work to open the door so I used the key, put it in the ignition, turn the key, the fan runs and the lights on the dash are light up but no noise from the ...
Question about Ford Econoline
...dash, BUT, this time around when it happens my climate controls also won't work. It will just show dashes on the temp display and won't let me operate any of the buttons. Any ideas? How are these two ...
Question about Mitsubishi Cars & Trucks
...I start the bus a siren sounds and a red bus light shows up on the right side of the dash panel,can you tell me what is going on please. notify mitsibisi for assistance or online search for a ...
Question about Plymouth Cars & Trucks
car wont turn over and the dash has no bus on it what can i do Sounds like a wiring harness got bumped or moved or something like that. check any wiring in the area where the hose you just replaced is
bus or under the dash on the drivers side of the vehicle. If you are in a country that drives on the left side of the road not sure if they switch the location of the fuse bus under the dashboard. But
...I replaced the fuse and reconnected the wire. It will turn over but no spark to plugs. It is not the crank shaft sensor as I already tried that. It also reads No Bus on the dash. so replace the ...
237 questions posted
Usually answered in minutes!
266 Questions
242 Questions
210 Questions
177 Questions
172 Questions